Nexxt Solutions - NW230NXT14 (Nexxt Firmware)
Port Triggering Guide
Note: An added benefit of Port Triggering is you do not need to worry about ip addresses.
When using port triggering with applications that don't make outbound
connections you can use my free
Port Triggering
Initiator to make the connections to trigger the ports for you.
Step 1.
Open your favorite web browser and input your routers ip address in the address bar.
Please note that you must have the http:// in order to connect to your
router/modem properly.
Need help finding you router IP address? Click here
Step 2.
Some router/modems require a username and/or password, if yours requires it, enter the routers username and password here.
If you don't know it you can check our list of default router and modem password list here.
If you have changed it and don't remember it you may have to reset your device to factory default using the reset button on most routers.
Step 3.
Once logged into your router click on "NAT".
Step 4.
Click 'Port Trigger' at the top of the page.
For 'Rule Name' Give your entry a name, it must not be the same as any others on this page.
For 'Trigger Protocol' select the protocol for the trigger port.
For 'Trigger Port' this will be what ports are used to trigger when to
open the ports.
Example: 2100 - 2200 or 3000 - 3000
For 'Forward Protocol' choose the protocol for the forwarded port.
For 'Forwarded Port' this will be the port to be forwarded.
Example: 2100
Click 'Add' once all information has been set.
Repeat this step for all ports.
Step 5.
Click 'Save'
All done!
